Avaya Configuring IP, ARP, RIP, and OSPF Services Uživatelský manuál Strana 259

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 362
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 258
Site Manager Parameters
117356-E Rev 00
A-19
IP Global Parameters
Parameter: Enable
Path: Configuration Manager > Protocols > IP > Global
Default: Enable
Options: Enable
|
Disable
Function: Specifies the state of the IP router software.
Instructions: Select Enable if you previously disabled the IP router software and now wish to
reenable it. Select Disable to disable the IP router software. In dynamic mode,
when you set this parameter to Disable, you immediately prohibit all Site
Manager communication with the router.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.2
Parameter: Forwarding
Path: Configuration Manager > Protocols > IP > Global
Default: Forwarding
Options: Forwarding
|
Not Forwarding
Function: Specifies whether the IP router forwards IP traffic that is not explicitly
addressed to it.
Instructions: Select Forwarding if you want the IP router to route (forward) IP traffic.
Forwarding configures the IP router to process all broadcast packets and all IP
packets explicitly addressed to it, and to route all other IP packets. Select Not
Forwarding if you want to provide IP management access (by means of TFTP
and SNMP) to all active IP interfaces but also want to prohibit the IP router
from forwarding IP traffic. You must specify an identical IP address and mask
combination for each active IP interface that will provide management access.
Not Forwarding configures the IP router to act as an IP host; it does not
forward IP traffic, but it still processes packets explicitly addressed to it. In
Not Forwarding mode, only static routes and adjacent-host routes are allowed.
No routing protocols are initiated. Because the IP router does not forward IP
traffic in Not Forwarding mode, you must configure the router to bridge IP
traffic not explicitly addressed to it. You must configure the bridge for each
circuit that conveys IP datagrams. The bridge then forwards all IP datagrams
that are not explicitly addressed to the router.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.4
Zobrazit stránku 258
1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 361 362

Komentáře k této Příručce

Žádné komentáře