Avaya Troubleshooting Routers Průvodce řešením problémů stáhnout pdf (Strana 174)

Troubleshooting Routers

A-18

308656-14.00 Rev 00

Dial-on-Demand Raise DTR Log

The following log shows a successful dial-on-demand connection between the

COM2 port in slot 2 and a modem configured for Raise DTR.

These messages appear only when you click on the port configured for

dial-on-demand, and set the Debug option under the Modem definition to

Enabled. If you are using the Technician Interface, set attribute #29 (the debug

attribute) of the object wfModemIfEntry to 1 (1 = enabled, 2 = disabled). The

Debug option is available with router software Version 8.01 and later.

The following message indicates that the Sync software module enabled the

COM2 port:

# 33: mm/dd/yy 14:14:02.826 INFO SLOT 2 SYNC Code: 9

Connector COM2 enabled.

The port completes initialization.

# 34: mm/dd/yy 14:14:03.095 DEBUG SLOT 2 SYNC Code: 16

Connector COM2 initialization complete

Environment address - 3051f040 Line record address -

3052d8bc

Hardware map address - 30514f9c Initialization block -

80007800

Receive descriptor ring - 80005000 Transmit descriptor ring -

80005800

# 35: mm/dd/yy 14:14:03.095 DEBUG SLOT 2 PCAP Code: 67

interface became local - line 202102

intf gate spawned - line 202102

# 36: mm/dd/yy 14:14:03.103 DEBUG SLOT 2 PCAP Code: 65

wait_state - line 202102

The FSM messages indicate that the modem and the router are communicating.

The first FSM message shows the state the router was in when the FSM Event that

follows occurred.

# 37: mm/dd/yy 14:14:04.100 DEBUG SLOT 2 SWSERV Code: 46

Connector COM2: FSM State: RDTR_DISCONNECTED(0)

Connector COM2: FSM Event: RDTR_EVENT_CCT_UP(1); isdn flags: 0x0

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 267 268

Žádné komentáře

Avaya Troubleshooting Routers Průvodce řešením problémů Strana 174