
Installing and Maintaining BN Platforms
5-16 109352-E Rev. A
Remove a routing engine module or SRM-F as follows:
1. Gently pull the inside of the board extractors at the end of the module
toward you.
The extractors swing open, pushing the module out of the backplane
connectors.
2. Place the routing engine module or SRM-F module in an antistatic
protective bag.
Insert a routing engine module or SRM-F module as follows:
1. If the routing engine module or SRM-F contains a power switch, ensure
that the switch remains pushed to the right in the on position
(F
igure 5-9).
Figure 5-9. Location of Power Switch on FRE/FRE-2 Module and SRM-F
2.
Holding the board extractors open, slide the module into the card guides
of the desired slot.
Note: If your FRE/FRE-2 or SRM-F is not equipped with a power switch, it
powers on automatically when you connect it.
Note: When inserting a module into a BLN or BLN-2, lift the middle of the
board slightly and push it gently to ensure that the connector in the middle of
the board engages.
Power Switch
Off On
Komentáře k této Příručce