Avaya (109352-E, Uživatelský manuál Strana 44

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 144
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 43
Installing and Maintaining BN Platforms
1-16 109352-E Rev. A
2. Remove the cable connector from the CONSOLE port of the System
Resource Module-Link (SRM-L).
The SRM-L is in Slot 1 of the BLN’s rear panel (Figure 1-6).
3. Insert one end of the cable (Order No. 77850) into the SRM-L
CONSOLE port.
4. Insert the other end of the cable into the RS-232 communications port at
the back of the modem.
To configure the BLN CONSOLE port for modem operation, refer to Configuring
Routers (router software) or Getting Started with Site Manager (BayStream
software).
Data Terminal Ready (DTR) signal DTR signal fail-disconnect enabled (return
to command mode, auto-answer off)
Data Carrier Detect (DCD) signal DCD signal on while carrier present (the
node uses DCD to detect modem
disconnect)
Local character echo OFF
Supervisory functions OFF
Data Set Ready (DSR) signal ON
Note: The console cable and the modem cable both connect to the BLN using
the CONSOLE port.
Table 1-9. Modem Operating Parameters
(continued)
Parameter Setting
Zobrazit stránku 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 143 144

Komentáře k této Příručce

Žádné komentáře