
Installing the Backbone Link Node-2
109352-E Rev. A 2-11
Installing the BLN-2
Install the BLN-2 in the electronic enclosure rack as follows:
1. Using both hands, pull the bottom of the front bezel toward you and
remove it from the chassis (F
igure 2-4).
Figure 2-4. Removing the Front Bezel from the BLN-2
Warning: The BLN-2 weighs approximately 125 lb. Do not attempt to lift it
by yourself. Use a team of people or specialized lifting equipment. Before
inserting the BLN-2 in the rack, ensure that all equipment already inside the
rack is secure.
Note: Before you place the BLN-2 in the rack, ensure that the rack holes are
threaded. If they are not threaded, place cage nuts over the front vertical
support holes.
Pull Bottom
POWER
RUN
BOOT
DIAG
B A C K B O N E N O D E
RESET
Komentáře k této Příručce