
Installing and Maintaining BN Platforms
4-10 109352-E Rev. A
b. Remove the bracket.
4. Pull the front of the air flow module forward to remove it (Figure 4-7.)
Insert an air flow module as follows:
1. Grasp the sides of the air flow module (Figure 4-8).
2. Correctly position the back edge of the air flow module to accommodate
the slot power connector and locating pin.
(For BCNs, hold the air module vertically, with the top edge up as noted in
Figure 4-8.)
3. Insert the air flow module as shown in Figure 4-6.
(For BCNs, insert the air module vertically, with the top edge up as noted in
Figure 4-8.)
4. Replace the board retainer bracket (BLN and BLN-2 only), EMC shield,
and front bezel.
Figure 4-7. Inserting or Removing an Air Flow Module
BACKBONE NODE
POWER
RUN
BOOT
DIAG
RESET
Komentáře k této Příručce