Avaya (109352-E, Uživatelský manuál Strana 42

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 144
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 41
Installing and Maintaining BN Platforms
1-14 109352-E Rev. A
The BLN indicates a successful start-up by turning off the BOOT LED. The
POWER and RUN LEDs remain on. Refer to Chapter 6, “Switches and LEDs,
for a complete explanation of all Backbone Node LEDs. To activate the BLN on
your IP network, refer to Quick-Starting Routers and BNX Platforms (router
software), or to Configuring an Interface for Network Management (BayStream
software).
Establishing a Local or Remote Connection to the BLN
You can cable a BLN to an ANSI console or a PC to establish a local Technician
Interface session, or to a modem to establish a remote session.
Local Connection
Cable the BLN to an ANSI console as follows:
1. Power on the console and set its operating parameters as shown in
Table 1-8.
Refer to your console user manual for instructions on how to set these
operating parameters.
2. Insert the male end of the cable (Order No. 7525) into the CONSOLE
port of the System Resources Module-Link (SRM-L) Module
(Figure 1-6).
The SRM-L resides in Slot 1 of the rear panel.
3. Insert the female end of the cable into the ANSI console communications
port.
Table 1-8. Console Operating Parameters
Parameter Value
Baud rate 9600
Data bits 8
Stop bits 1
Parity None
Zobrazit stránku 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 143 144

Komentáře k této Příručce

Žádné komentáře