Avaya (109352-E, Uživatelský manuál Strana 52

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 144
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 51
Installing and Maintaining BN Platforms
2-8 109352-E Rev. A
b. Locate the next two holes below this spot that have a 0.625-in. space
between them.
2. Mount the angle brackets in the area indicated by Figure 2-3.
a. If your rack does not have threaded holes, place cage nuts over the
holes before you attach the angle brackets.
b. Align the edge of the brackets to the rack as follows:
-- If the interior of the rack contains horizontal bracket supports, align
the angle bracket with the horizontal bracket support.
-- If the interior of the rack does not contain horizontal bracket supports,
brace the angle bracket between the side rails.
You must orient the brackets that support the hardware platform as shown
in Figure 2-3. Ensure that you can adjust the bracket vertically along its
slots before you secure it.
c. Insert two 10-32 screws through each bracket’s slotted holes and into
the holes in the supports of the rack. Do not tighten the screws.
d. Adjust each bracket vertically along the bracket slots until the
bracket is 1.4 in. (3.6 cm) below the center of one hole in the front
vertical support of the rack.
e. Tighten the screws with a screwdriver until secure.
Note: The hole pattern shown in Figure 2-2 repeats on the rail.
Zobrazit stránku 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 143 144

Komentáře k této Příručce

Žádné komentáře