Avaya (109352-E, Uživatelský manuál Strana 77

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 144
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 76
Installing the BCN and BCN RLC
109352-E Rev. A 3-15
2.
Insert and tighten the screws with a screwdriver until secure.
Replace the front bezel as follows:
1. Align the mounting retainers on the inside of the bezel with the holes on
the front of the electromagnetic compatibility (EMC) shield.
2. Push the sides of the bezel into place.
Insert each power module as follows:
1. Grasp the handle and guide the module into the desired slot along the
side guides and gently insert the module until the power supply connector
comes into contact with the connector on the power supply backplane.
2. Using a flat-head screwdriver, turn the captive screw until the power
module seats firmly.
The Power OK LED lights when the BCN powers on and the power module
fully engages.
3. Turn the captive screw an additional 1/4 turn. Do not overtighten the
screw.
Powering On the BCN or BCN RLC
Power on the BCN or BCN RLC as follows:
1. Ensure that the power switch(s) on the rear panel is in the OFF (down or
0) position.
2. Connect the power plug(s) to the AC inlet(s) on the BCN rear panel.
3. Insert the power plug(s) into the appropriate wall receptacle.
Refer to “Electrical Requirements” earlier in this chapter.
4. Turn the power switch(s) to the ON (up or 1) position.
Note: Stop when you feel resistance. The power module does not fully insert
until you tighten the thumbscrew.
Zobrazit stránku 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 143 144

Komentáře k této Příručce

Žádné komentáře