
Hot-Swapping Hardware Components
109352-E Rev. A 5-23
Figure 5-11. Removing a Power Module from a BCN
Insert a BCN power module as follows:
1. Grasp the handle and guide the module into the desired slot along the
side guides and gently insert the module.
2. Tighten the captive thumbscrew until the power module is seated firmly.
3. Turn the captive screw no more than an additional 1/4 turn. Do not
overtighten the screw.
Note: Stop when you feel resistance. The power module does not fully insert
until you tighten the thumbscrew.
Note: If the hardware platform is on, the Power OK LED turns on when the
power module connector comes into contact with the connector on the power
module backplane.
Screw
Power OK
Komentáře k této Příručce