Avaya Configuring ATM and MPLS Services Uživatelský manuál Strana 103

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 529
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 102
Starting ATM, ATM MPOA Server, ATM Router Redundancy, and MPLS
117374-C Rev 00
3-17
Creating an MPS Service Record
To run MPS over ATM, you must create an MPS service record that ATM
recognizes. The MPS service record is the base on which you add MPOA servers
(MPSs).
To create an MPS service record, complete the following tasks:
By default, when you enter and then exit the MPOA Service Record window, you
automatically create and enable the MPOA service record using the default
settings. You need only enter and exit this window one time to create and enable
the MPOA service record. However, for MPOA to operate, you must add at least
one MPS to the service record.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
click on an ATM link module interface
(
ATM1
).
The Select Connection Type window
opens.
2. Click on
ATM
. The Edit ATM Connector window opens.
3. Click on
MPOA Server Attributes
. The MPOA Server Parameters window
opens.
4. Click on
OK
. The MPOA Service Record window
opens.
5. Got to the next section, “Adding an MPS to
the MPS Service Record,” to add an MPS
to the MPOA service record, or go to the
next step to exit this procedure.
6. Click on
Done
. You return to the Edit ATM Connector
window.
7. Click on
Done
. You return to the Select Connection Type
window.
8. Click on
Done
. You return to the Configuration Manager
window.
Note:
You can currently have only one MPOA service record per ATM
interface. However, this service record can contain up to four MPOA servers.
Zobrazit stránku 102
1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 528 529

Komentáře k této Příručce

Žádné komentáře