Avaya Configuring ATM and MPLS Services Uživatelský manuál stáhnout pdf (Strana 131)

100

101

Customizing an ATM Interface

117374-C Rev 00

4-5

Defining the Data Path Notify Function

The data path notify function specifies whether the router disables the interface

between the driver and the higher-level software (the data path interface) when

you disconnect the cable from the ATM interface.

If you enable this function (the default), when you disconnect the cable from the

interface, the router disables the data path interface after a time you specify.

If you disable this function, the router does not disable the data path interface and

continues to send information to the higher-level software.

When you enable the data path notify function, you can also change how long you

want the ATM router to wait before disabling the data path interface. By default,

when the state of the physical interface changes from operational to

nonoperational, the router waits 1 second. However, you can set this timer to any

value from 0 to 3600 seconds.

Using the BCC

To disable the data path notify function, navigate to the atm prompt (for example,

box; atm/11/1

) and enter:

dp-notify disabled

For example, the following command disables the data path notify function on the

ATM interface:

atm/11/1#

dp-notify disabled

atm/11/1#

To reenable the data path notify function, navigate to the atm prompt and enter:

dp-notify enabled

To change the data path notify timeout value, navigate to the atm prompt and

enter:

dp-notify-timeout

integer

is the amount of time (in seconds) that the router can wait before the data

path notify function activates.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 528 529

Komentáře k této Příručce

Žádné komentáře

Avaya Configuring ATM and MPLS Services Uživatelský manuál Strana 131

Komentáře k této Příručce

Související produkty a manuály pro Sítě Avaya Configuring ATM and MPLS Services