Avaya Configuring ATM and MPLS Services Uživatelský manuál stáhnout pdf (Strana 106)

100

101

Configuring ATM and MPLS Services

3-20

117374-C Rev 00

Configuring an SVC Control Connection

MPOA requires a connection between each MPS in an MPOA network over

which it can send NHRP control data. If you configure each LEC with NHRP, you

do not need an SVC control connection. However, you can configure a separate

control SVC to manage control traffic from the LEC.

When configuring the SVC control connection, keep the following in mind:

• The SVCs must use LLC/SNAP encapsulation (you cannot use NLPID or

NULL encapsulation on the SVC).

• You must configure the SVC with IP and NHRP.

• Bay Networks recommends that you configure the SVC to run RIP (to avoid

manually configuring adjacent hosts for each MPS).

• You must set the client mode for the SVC to client on one MPS and server on

the other MPS.

For instructions on configuring an SVC service record with LLC/SNAP

encapsulation, see “Defining Classical IP Service

” on page 3-4 (BCC) or “Adding

a Service Record for Classical IP” on page 3-11 (Site Manager).

After you create an SVC service record, the Add Protocols window opens. To add

IP, NHRP, and RIP to an SVC service record, complete the following tasks:

Site Manager Procedure

You do this System responds

1. Click on

. A check mark appears in the IP box.

2. Click on

RIP

. A check mark appears in the RIP box

3. Click on

NHRP

. A check mark appears in the NHRP box.

4. Click on

. The IP Configuration window opens.

5. Set the following parameters:

• IP Address

• Subnet Mask

• Transmit Bcast Address

Click on

Help

or see

Configuring IP

Services

for parameter descriptions.

(continued)

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 528 529

Komentáře k této Příručce

Žádné komentáře

Avaya Configuring ATM and MPLS Services Uživatelský manuál Strana 106

Komentáře k této Příručce

Související produkty a manuály pro Sítě Avaya Configuring ATM and MPLS Services