Avaya Configuring ATM and MPLS Services Uživatelský manuál Strana 268

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 529
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 267
Configuring ATM and MPLS Services
8-14
117374-C Rev 00
Specifying an Emulated LAN Segment ID
You must specify an emulated LAN segment ID when:
The LANE client is a token ring end station. A LANE client is a token ring
end station when it resides at the edge of a token ring network.
You are routing IP or IPX across a source route bridging (SRB) token ring
network.
The emulated LAN segment ID specifies the ring ID (in decimal) on which the
LANE client resides. By default, this value is set to 0. However, you can specify a
value from 0 to 4095 for the token ring segment ID.
To change the emulated LAN segment ID, complete the following tasks:
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
click on the ATM interface (
ATM1
) that you
want to modify.
The Select Connection Type window
opens.
2. Click on
ATM
. The Edit ATM Connector window opens.
3. Click on
Service Attributes
. The ATM Service Records List window
opens.
4. Click on the LANE service record that you
want to modify.
5. Click on
LEC
. The LAN Emulation Parameters window
opens.
6. Set the
Emulated LAN Segment ID
parameter. Click on
Help
or see the
parameter description on page A-35.
7. Click on
OK
. You return to the ATM Service Records
List window.
8. Click on
Done
. You return to the Edit ATM Connector
window.
9. Click on
Done
. You return to the Select Connection Type
window.
10. Click on
Done
. You return to the Configuration Manager
window.
Zobrazit stránku 267
1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 528 529

Komentáře k této Příručce

Žádné komentáře