
BayRS Version 15.5.0.0 Document Change Notice
21-2 314470-15.5 Rev 00
Enabling and Disabling GRE Keepalive Messages for a Remote Tunnel
End Point
The GRE keepalive message functionality is disabled by default.
You can use the BCC or Site Manager to enable and disable the transmission of
GRE keepalive messages between a GRE tunnel’s local end point and one of its
configured remote tunnel end points.
Using the BCC
To enable and disable the transmission of GRE keepalive messages between a
tunnel’s local end point and one of its remote tunnel end points, navigate to the
remote GRE tunnel interface prompt (for example,
box; tunnels; gre/boston;
remote-endpoint/austin
) and enter:
keepalive <state>
state
is one of the following:
enabled
disabled
(default)
For example, the following command sequence enables transmission of GRE
keepalive messages between the local end point and the remote end point austin
and verifies the change:
remote-endpoint/austin# keepalive enabled
remote-endpoint/austin# info
address 192.168.2.4
keepalive enabled
logical-ip-address 0.0.0.1
logical-ipx-address 000000000001
name austin
keepalive-retries 3
keepalive-retry-timeout 10
state enabled
Komentáře k této Příručce