Avaya BayRS Version 15.5.0.0 Uživatelský manuál Strana 62

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 198
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 61
BayRS Version 15.5.0.0 Document Change Notice
8-2 314470-15.5 Rev 00
Version 15.4.0.0
The following sections are amendments to Configuring IP, ARP, RIP, RARP, and
OSPF Services.
Defining BGP Peers for BGP, OSPF, and RIP Announce Policies
When defining a BGP peer for an announce policy, the peer must be identified by
its BGP router ID. To verify the router ID of the BGP peer, on the peer router,
check the configured value for the Site Manager BGP Global parameter, BGP
Identifier, or the BCC BGP parameter, router-id. For information about supplying
a router ID for a BGP router, see Configuring IP Exterior Gateway Protocols
(BGP and EGP).
Importing RIP updates
You can now select whether the router imports RIP-1 updates only, RIP-2 updates
only, or both RIP-1 and RIP-2 updates from a neighbor router. The following
procedures describe how to configure this feature using the BCC and Site
Manager.
Using the BCC
To have RIP-1 accept both RIP-1 broadcast and RIP-2 multicast packets (and
have RIP-2 always use multicast for transmitting updates), go to the RIP interface
prompt (for example,
box; eth 2/2; ip/10.1.1.2/255.255.0.0; rip) and enter:
rip1-comp disable
For example, to disable rip1-comp, enter:
rip/10.1.1.2# rip1-comp disable
rip/10.1.1.2#
To have RIP-1 accept RIP-1 broadcast and RIP-2 broadcast packets only (RIP-1
will not accept RIP-2 multicast packets) and have RIP-2 broadcast the packets,
making it compatible with RIP-1, go to the RIP interface prompt (for example,
box; eth 2/2; ip/10.1.1.2/255.255.0.0; rip) and enter:
rip1-comp enable
Zobrazit stránku 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 197 198

Komentáře k této Příručce

Žádné komentáře