
Site Manager Parameters
314470-15.5 Rev 00 A-7
ATM Port Parameters
You use the following parameters to configure the ATM T3/E3 interface on the
Passport 5430.
Parameter: Enable/Disable
Path: Configuration Manager > ATM1 > Physical Layer Configuration > DS3 or E3
Default: Enable
Options: Enable
| Disable
Function: Enables or disables this interface.
Instructions: Set to Disable only if you want to disable the interface.
MIB Object ID: 1.3.6.1.4.1.18.3.4.26.10.1.2
Parameter: Line Type
Path: Configuration Manager > ATM1 > Physical Layer Configuration > DS3 or E3
Default: Autodetect
Options: For DS3, the options are DS3 M23
| DS3 CBIT Parity | Autodetect
For E3, the options are E3 Framed
| E3 PLCP
Function: Sets the frame format for this interface.
Instructions: Determines the framing mode for this interface.
For DS3, if you choose DS3 M23 or DS3 CBIT Parity, be sure that the ATM
line attribute Framing Mode is appropriately set:
If the Line Type is DS3 M23, Framing Mode should be DS3_M23 or
T3M23PLCP.
If Line Type is DS3 CBIT Parity, Framing Mode should be DS3_CBIT or
T3CBITPLCP.
For E3, make sure that the ATM line attribute Framing Mode is set to either
E3_G751 or E3_G832.
MIB Object ID: 1.3.6.1.4.1.18.3.4.26.10.1.7
Komentáře k této Příručce