
Configuring ATM Services
314470-15.5 Rev 00 3-7
After you create the ATM circuit, go to Chapter 2, “Starting ATM and ATM
Router Redundancy,” in Configuring ATM Services to finish configuring ATM
services.
Configuring ATM Services also provides more information about ATM services
and how to modify an existing ATM configuration.
9. Set the the following parameters as
needed:
•Enable
•Interface MTU
• Data Path Enable
• Data Path Notify Timeout
• Framing Mode
• Cell Scrambling
• Per-VC Clipping
• DS3 Line Build Out
Note: The Cell Scrambling parameter
value must be the same as for the other
ATM devices on your network. See your
system administrator or your service
provider for the appropriate value.
Click on Help or see the parameter
descriptions in “ATM Line Parameters
” on
page A-3
.
10. Click on OK. The ATM Configuration window opens.
11. Click on ATM. The Edit ATM Connector window opens.
12. Go to “Defining an ATM Service Record” in
Configuring ATM Services.
Site Manager Procedure (continued)
You do this System responds
Komentáře k této Příručce