Avaya BayRS Version 15.5.0.0 Uživatelský manuál stáhnout pdf (Strana 29)

Configuring ATM Services

314470-15.5 Rev 00 3-5

For example, the following command sets the clock source to internal:

atm-e3/1/1/2/1# primary-clock-source internal

atm-e3/1/1/2/1#

Specifying the Setup Alarm Threshold

To specify the duration of time (in seconds) that elapses following the detection of

a performance failure, before the condition is registered and logged, navigate to

the ATM interface prompt (for example, box; atm/1/1/2/1; atm-e3) and enter:

setup-alarm-threshold <integer>

integer

is a value from 2 through 10 seconds, inclusive.

For example, the following command changes the setup alarm threshold from 2 to

8 seconds:

atm-e3/1/1/2/1# setup-alarm-threshold 8

atm-e3/1/1/2/1#

Disabling and Reenabling the ATM interface

By default, the ATM interface is enabled when you create the circuit. However,

you can disable or reenable the interface at any time. When the interface is

enabled, traffic can flow over the interface. When the interface is disabled, traffic

cannot flow over the interface.

To disable or reenable the ATM interface, navigate to the ATM interface prompt

(for example,

box; atm/1/1/2/1; atm-e3) and enter:

state {disabled | enabled}

For example, the following commands disable and reenable the ATM interface:

atm-e3/1/1/2/1# state disabled

atm-e3/1/1/2/1# state enabled

atm-e3/1/1/2/1#

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 197 198

Žádné komentáře

Avaya BayRS Version 15.5.0.0 Uživatelský manuál Strana 29