
314470-15.5 Rev 00 6-1
Chapter 6
Configuring Ethernet, FDDI, and Token Ring
Services
Version 15.4.0.0
The following section is new to Chapter 2 of Configuring Ethernet, FDDI, and
Token Ring Services.
The sections “Router Processing of Tagged Frames,” “Implementation
Considerations,” “Adding a Tagged Circuit to an Unconfigured 10BASE-T or
100BASE-T Interface,” and “Adding a Tagged Circuit to an Existing 10BASE-T
or 100BASE-T Interface” contain amendments to Chapter 5 of Configuring
Ethernet, FDDI, and Token Ring Services.
Specifying the DSQMS Line Speed
You specify the DSQMS line speed using the dsqms-line-speed parameter. You
access this parameter by navigating to the ethernet prompt (for example,
box;
ethernet 2/1) and entering the following command
dsqms-line-speed <value>
value specifies the line speed (in bits per second) for the DSQMS client. The
default is 1250000 (1.25Mbps).
In network configurations where the Ethernet interface is connected to an external
access device such as DSL or a Cable modem, the dsqms-line-speed parameter
can be used in conjunction with dequeue-at-line rate parameter enabled on the
egress interface and traffic policing on the ingress interface for traffic
management.
Komentáře k této Příručce