Avaya BayRS Version 15.5.0.0 Uživatelský manuál Strana 81

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 198
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 80
314470-15.5 Rev 00 12-1
Chapter 12
Using the Technician Interface Software
Version 15.1.0.0
The Technician Interface is a command-line interface that Nortel Networks
support technicians can use to troubleshoot and configure Nortel Networks
devices.
The following sections are amendments to Using the Technician Interface
Software:
Diagnostics On/Off Option for ARN, Passport 2340, and Passport 5430
For ARN, Passport 2430 and Passport 5430 platforms only, the Technician
Interface
diags command supports an option to enable or disable diagnostics,
effective the next time you cycle power on the router. Disabling the diagnostics
results in a faster boot time, but leaves the hardware components unverified. The
syntax for this option is as follows:
diags [-on|off] [<slot_id>]
Setting Default Route Cost Using the Technician Interface
When the routing table does not contain the route to a particular destination
address, the router looks for a default route. As it does for any other route, the
routing table either acquires the default route dynamically (through a routing
protocol), or you can enter the default route statically.
Zobrazit stránku 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 197 198

Komentáře k této Příručce

Žádné komentáře