
BayRS Version 15.5.0.0 Document Change Notice
23-4 314470-15.5 Rev 00
show gre physical-tunnels
The show gre physical-tunnels command displays information about the router
interfaces at either end of the physical GRE tunnel. This command allows for the
following command filters and arguments:
The output includes the following information:
State State of the GRE connection: up or down. The state of a
connection is ‘up’ unless it is declared ‘down’ (as a result
of keepalive failure) or the GRE connection is disabled.
Timer Interval of time (in seconds) between transmission of
successive keepalive packets to the remote endpoint.
Retries Amount of time to wait before declaring a GRE
connection ‘down’. ‘Retries’ is expressed as a multiple of
the configured Timer value, where “Retries” is the number
by which the Timer value is multiplied.
-disabled Displays information about disabled tunnels only.
-enabled Displays information about enabled tunnels only.
-address <address> Displays information for tunnels configured with the
specified IP address only.
-name <name> Displays information for tunnels configured with the
specified name only. When you specify this filter, displays
both the filter flag and value (that is, long notation).
<
name> Displays information for tunnels configured with the
specified tunnel name only. When you specify this filter,
displays a value only (that is, short notation).
Tunnel Name Name assigned to the GRE tunnel.
Local Address IP address of the router interface on which the GRE
tunnel is configured.
Local State State of the router interface: enabled or disabled.
Remote Endpoint Name Name assigned to the interface at the tunnel’s remote end
point.
Remote Endpoint Address IP address of the interface at the tunnel’s remote end
point.
Encaps Protocols Protocol for which the tunnel is configured.
Komentáře k této Příručce