Avaya BayRS Version 15.5.0.0 Uživatelský manuál stáhnout pdf (Strana 88)

BayRS Version 15.5.0.0 Document Change Notice

13-4 314470-15.5 Rev 00

Enabling or Disabling Protocol Priority

When you configure Protocol Priority on a circuit, it is enabled by default. To

disable Protocol Priority, navigate to the protocol priority prompt (for example,

box; ethernet/2/1; protocol-priority) and enter:

state disabled

If you set this parameter to disabled, all outbound traffic filters will be disabled on

this interface. Setting this parameter to disabled is useful if you want to

temporarily disable all outbound traffic filters rather than delete them.

To re-enable Protocol Priority, navigate to the protocol priority prompt (for

example,

box; ethernet/2/1; protocol-priority) and enter:

state enabled

For example, the following command enables Protocol Priority on the selected

circuit:

protocol-priority/ethernet/2/1# state enabled

protocol-priority/ethernet/2/1#

Specifying the High Queue Size

To specify the maximum number of packets in the High queue at any one time,

regardless of packet size, navigate to the protocol priority prompt (for example,

box; ethernet/2/1; protocol-priority) and enter:

high-queue-size <value>

value

is any integer value; the default is 20.

For example, the following command changes the high queue size to 50:

protocol-priority/ethernet/2/1# high-queue-size 50

protocol-priority/ethernet/2/1#

Selecting the Low Queue Percentage Bandwidth

13-8

Controlling the Dequeuing of Packets 13-8

Procedure Page

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 197 198

Žádné komentáře

Avaya BayRS Version 15.5.0.0 Uživatelský manuál Strana 88